PPP-PT (Control LAN Packet/Port)
Issue 1 June 2005 1903
PPP Link Status Inquiry Test (#1279)
This nondestructive test determines the state of the PPP link. The test passes only if the link is
up.
2500 ABRT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
1 FAIL System software indicates at least one PPP link session is down (SOME
UP).
1. Isolate downed sessions (status port location or status
link n).
Follow actions based on session information.
2 FAIL System software indicates every PPP session is down (ALL DOWN).
1. Test the port (test port location) to verify the SCOTCH
Synchronous Loop-around test (#1275) result.
2. If test passes, wait for system software to indicate ALL UP.
3. If the test fails, check the destination and other components in the
path.
4. If the destination and other components in the path are in-service,
take action based on session information.
PASS Every session up.
Table 695: Test #1286 Session Status Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2
Table 696: Test #1279 PPP Link Status Inquiry Test
Error
Code
Test
Result
Description / Recommendation
1124 ABRT ppp link is not enabled.
1. Verify that the ppp link is enabled (status port location,
status link n, or display data-module).
2. If the link is not enabled, enable the link (change data-module).
3. Repeat the test.
1 of 2