Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
2284 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Port Audit and Update Test (#36)
This test sends port level translation data from switch processor to the DS1 Interface circuit
pack or media module to ensure that the trunk’s translation is correct. Translation updates
include the following data: trunk type (in/out), dial type, timing parameters, and signaling bits
enabled. The port audit operation verifies the consistency of the current state of the trunk kept
by the DS1 Interface circuit pack or media module and the switch software.
Table 817: Test #36 Port Audit and Update Test
Error
Code
Test
Result
Description / Recommendation
ABRT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test were not available. The port
may be busy with a valid call.
1. Use display port location to determine the trunk group/
member number of the port. Use status trunk to determine the
service state of the port. If the service state indicates that the port is in
use, then the port is unavailable for certain tests. Wait until the port is
idle before retesting.
2. If the port status is active but the port is idle (no calls), check the error
log for Error Type 1025 (see the error log table for a description of this
error and required actions). The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals up to
5 times.
1006 ABRT The test was aborted because the trunk is out of service.
1. Use status trunk to verify that the trunk is out of service.
2. If the trunk is out of service, determine why.
3. If it is OK to put the trunk back in service, enter release trunk to
restore the trunk’s service, and then retry the test.
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2