ANL-16-L (16-Port Analog Line)
Issue 1 June 2005 393
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call. This result is also reported for the system’s
Music-On-Hold port when it is off-hook, which it usually is.
1. Enter display port location to determine the station’s extension.
Enter status station extension to determine the service state of
the port. If the port is active, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
1004 ABRT The port was seized by a valid call during the test.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If the
port is active, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABRT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABRT The test has been disabled by administration. The default for the Test field
on the station screen is y. Determine why this field was set to n on this
station. It may be due to the ringing application Test #48, which can be
customer or terminal disturbing.
1. To enable the test for the particular analog station being tested, enter
change station extension and set the Test field on the station to
y.
S8700
| 8710
S8500
S8300
1392
ABRT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either display port, which
shows that the port is a TTI port) or list config, which shows a t for
the port.
2. If the port is not a TTI port, escalate the problem. If both commands
indicate that the port is a TTI port, the abort is correct for the test, and
no action is necessary.
Table 115: Test #35 Battery Feed Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3