Filter
Top Products
FIBER-LK (Fiber Link)
Issue 1 June 2005 1253
d. The media server is not acknowledging messages from the DS1 converter circuit pack or
the DS1 converter circuit pack does not have a processor route. This pattern indicates a
probable software problem.
In addition to the traditional red, green, and amber LEDs, the DS1 converter circuit pack has
four green LEDs that indicate whether a receive signal is present for each DS1 facility.
Error Log Entries and Test to Clear Values
Notes:
a. The failure audit test (#777) should be run to confirm whether the error still exists.
b. Error Type 1: indicates problem with the control path to the neighbor. See Repair
procedures.
Table 431: Fiber Link Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Test to Clear Value
0
1
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each
appropriate test’s description, and follow its recommended procedures.
0 Any Any Any test fiber-link F P r 1
1 (b
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1
18 (c
)0busyout fiber F P WRN OFF release fiber F P
257 (d
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1
513 (e
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1
769 (f
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1
1025 (g
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1
1281 (h
) any Failure audit (#777) (a)MAJ
MIN
WRN
OFF test fiber-link F P r 1