Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
1620 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2000 ABRT Response to the test was not received within the allowable time period.
This may be due to hyperactivity. Error Type 1538 in the error log indicates
hyperactivity. The hyperactive Media Module is out of service and one or
more of the following symptoms may be exhibited:
The MG-DS1 tests (such as Test #138 and Test #139) are aborting
with Error Code 2000.
The tests run on the ports of this Media Module are returning a no
board result.
A busyout or a release command has no affect on the test
results.
A list config command shows that the Media Module and the
ports are properly installed.
When hyperactivity occurs, the Media Module is isolated from the
system, and all of the trunks for this Media Module are placed into the out
of service state. The system will try to restore the Media Module within 15
minutes. When no faults are detected for 15 minutes, the MM710
interface Media Module is restored to normal operation. All of the trunks
for the MM710 interface Media Module are then returned to the in service
state. Hyperactivity is often caused by the associated facility. In such a
case, faults (such as slips, misframes, or blue alarms) would be entered
in the error log. In addition, many hardware errors would be logged
against the associated trunk circuits.
1. If the facility is OK and the error occurs again after 15 minutes,
replace the Media Module.
Table 595: TEST #141 Yellow Alarm Inquiry Test (continued)
Error
Code
Test
Result
Description/ Recommendation
2 of 6