Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
ANL-16-L (16-Port Analog Line)
Issue 1 June 2005 391
1004 ABRT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port location to determine the station extension.
Use status station to determine the service state of the port. If
the port is active, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABRT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1018 ABRT The test has been disabled by administration. The default for the Test field
on the station screen is y. Determine why this field is n on this station. This
may be due to the ringing application Test #48, which can be customer or
terminal disturbing.
1. To enable the test for the particular analog station being tested, enter
change station extension and set the Test field on the station
to y.
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT System resources required to run this test are not available.
1. Resolve any TONE-PT errors.
2. If there are no TONE-PT errors in the error log, retry the test at
1-minute intervals for a maximum of 5 times.
Any FAIL The NPE of the tested port did not conference the tones correctly. This
causes noisy and unreliable connections.
1. Enter display port and status station to determine whether
the station is idle. If the station is idle, enter test port for this port.
2. If the test continues to fail, enter busyout port and release port,
and retest.
3. If the test still fails, replace the board.
PASS The port can correctly conference multiple connections. User-reported
troubles on this port should be investigated by using other port tests and by
examining station, trunk, or external wiring.
Table 114: Test #7 Conference Circuit Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3