Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
2070 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
122 FAIL The SNI circuit pack cannot communicate with its neighbor via the circuit
path.
1. Fix any on-board errors (SNI-BD, EXP-INTF, and/or DS1C-BD)
against the components of this fiber link by using display errors
and display alarms and following the repair procedures. (Use the
list fiber-link command to find the fiber link associated with
this SNI. The display fiber-link command can then be used to
find the endpoints of the fiber link and the DS1C circuit pack locations
if this fiber link has a DS1 Converter complex administered.)
2. Enter display errors and follow the repair procedures for any
FIBER-LK entries for the fiber this SNI is administered on. Check
list fiber-link to determine the administered fiber.
3. If this fiber link has a DS1 converter complex administered, enter
display errors and display alarms and follow the repair
procedures for any off-board DS1C-BD or DS1-FAC entries for either
of the DS1C boards administered or for the DS1 facilities associated
with either of the DS1C boards administered.
4. Replace this SNI.
PASS The SNI passed the sni circuit path test.
0NO
BOARD
No board was detected by the test.
1. Check that board is properly translated and inserted.
2. Run the test again. If it fails, reset the board. An SNI should be reset
instead of reseating the circuit pack. The reset board command
should almost never be used on an SNI. It may be necessary to use
reset board if the SNI circuit pack gets into a mode where it cannot
communicate with software. If an SNI with active errors and alarms is
reset, the errors and alarms may take a while to come back, therefore
reset board can mask real problems.
3. Run the test again. If it fails, the ID chip on board may be bad.
Replace the board and retest.
Table 749: TEST #755 SNI Circuit Path Test (continued)
Error
Code
Test
Result
Description / Recommendation
11 of 11