Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
432 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Conference Circuit Test (#7)
S8300 / G700: This test aborts with Error Code 1412.
This test verifies that the NPE channel for the port being tested correctly performs the
conferencing function.
Any FAIL This test can fail due to either on- or off-board problems. Off-board
problems include TDM-BUS faults, EXP-PN, EXP-INTF, and RMC-ENV
faults, and faults associated with the Tone Detectors/Tone Generators.
Clear every off-board problem before replacing the board.
1. A TDM-BUS problem is usually the result of a faulty board connection
to the backplane, or bent pins on the backplane. Resolve any
TDM-BUS errors in the error log.
2. Resolve any any EXP-PN, EXP-INTF, and RMC-ENV errors in the
error log.
3. Resolve any TONE-BD and/or TONE-PT errors in the error log.
4. Test the board when the faults from steps 1, 2, and 3 are cleared.
Replace the board only if the test fails.
PASS The port is correctly using its allocated time slots. Investigate user-reported
troubles on this port by running other port tests, by examining station wiring,
or by inspecting the station.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Enter
list configuration and resolve any problems.
2. If the board is correctly inserted, enter busy board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the link between the internal ID and the port. If not,
verify that a valid board is inserted.
Table 126: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
4 of 4