Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
IPMEDPRO (TN2602AP IP Media Resource 320)
Issue 1 June 2005 1391
Ping Test (#1379)
This test is nondestructive.
This test verifies that the IP Media Resource can communicate with other nodes on the LAN.
This test pings the gateway IP address as defined on the IP Interface screen. If the PING is
successful, this test looks at the PING round-trip delay. If a round-trip delay of greater than 4
seconds is reported, a separate error is logged. Excessive round-trip delays do not take the IP
Media Resource out of service.
Services can execute the standard PING command using the C-LAN board address and IP
Media Resource IP address to see the actual round-trip delay. (See ping commands.)
Table 491: Test #1379 Ping Test
Error
Code
Test
Result
Description / Recommendation
1,
2
ABRT
Internal Error.
1. Retry the command at 1-minute intervals up to 3 times.
7 ABRT Destination unreachable.
1. Verify that at least one destination reachable through this port is up.
2. Repeat the test.
3. If the test still aborts, escalate the problem.
1005 ABRT Configuration for this test is incorrect.
1. Verify that the Ethernet link is in-service with the status port or
status link command. Verify that the routing table has destinations
that are reachable through this port.
2. Repeat this test.
3. If the test aborts with error code 7 while step 1 verified, escalate the
problem.
2000 FAIL Response to the test was not received from the IP Media Resource within
the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack. Reset
the circuit pack by entering busyout board location and reset
board location.
2. If this result occurs again, replace the circuit pack.
2012 ABRT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
1 of 2