Filter
Top Products
ANL-LINE (8-Port Analog Line)
Issue 1 June 2005 419
1005 ABRT The test was aborted due to a configuration problem. This error code
occurs under either of the following conditions:
● This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, a modem pool
member or music on hold).
● The circuit pack is one of the following:
- TN742 vintage 13, 14, or 15
- TN769 vintage 3, 4, or 5
1018 ABRT Test disabled by administration. The default for the Test field is y.
Determine why the field is n on this station. It may be due to the ringing
application test 48, which can be customer or terminal disturbing.
1. To enable the test for a particular station, enter change station
extension and set the Test field on the Station screen to y.
1392 ABRT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either display port to show
that the port is a TTI port, or list config, where the display shows
a t for the port.
2. If either list config or display port indicate that the port is not
a TTI port, escalate the problem. If both commands indicate that the
port is a TTI port, the abort is correct for the test, and no action is
necessary.
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT System resources required to run this test are not available. Either a
system allocation to get information about the port or to put the port into a
service state failed or the attempt to put the port in connection with a tone
source failed (this could be a Tone-Clock problem). The Tone-Clock and
Tone Detectors could be having a communication problem. For example,
the companding modes could be out of synchronization.
1. Retry the command at 1-minute intervals up to 5 times.
Table 123: Test #47 Loop Around and Conference Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 5