Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
844 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the trunk group/
member number of the port. Use status trunk to determine the
service state of the port. If the service state indicates that the port is
active, then it is unavailable for certain tests. Wait until the port is idle
before retesting.
2. Retry the command at 1-minute intervals up to 5 times.
1001 ABRT System resources required to run this test were not available. This could
be due to a failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due
to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
retry the command at 1-minute intervals up to 5 times.
1004 ABRT The port was seized by a user for a valid call.
1. Use display port location to determine the trunk group/member
number of the port. Use status trunk to determine the service state
of the port. If the service state indicates that the port is active, then it is
unavailable for certain tests. Wait until the port is idle before retesting.
2. If the port status is idle, retry the command at 1-minute intervals up to 5
times.
1005 ABRT Trunk has been administered as incoming-only; dial tone can only be
obtained on outgoing trunks. This is a normal condition.
1018 ABRT Test has been disabled by administration.
1. Verify that the Maintenance Tests field on the Trunk Group form is
set to n. To enable the test, use change trunk-group x where <x>
equals the number of the trunk group to be tested. Enter y in the
Maintenance Tests field.
2000 ABRT Response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
Table 288: Test #0 Dial Tone Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 4