Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
1506 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Customer-Provided Alarming Device Test (#115)
Within a specified PN, the Customer-Provided Alarming Device (CPAD) test closes the relay
that activates the CPAD for 1 minute. If more than 1 minute is necessary to verify the CPAD’s
activation, the Repeat field on test customer-alarm location can be used to close the
relay for up to 99 minutes.
2500 Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The serial link between the currently standby EI or standby IPSI circuit
pack and the PN’s Maintenance circuit pack is defective. If the standby
EXP-INTF or IPSI is on Carrier A, then error type 3329 is logged. If the
standby EXP-INTF or IPSI is on Carrier B, then error type 3585 is logged.
1. If error type 3585 was logged:
● See if the ICCA/ICCB cables between carriers A and B are present
and properly connected (ICCA to ICCA, and ICCB to ICCB).
● See if the ICCC/ICCD cables between carriers A and B are present
and properly connected (ICCC to ICCC, and ICCD to ICCD).
● If the IPSI has faceplate ICC cables See if the faceplate cables
between the IPSIs and Maintenance circuit pack are properly
connected.
2. Install or reconnect the cables if necessary, and rerun the test.
3. Replace the PN’s Maintenance circuit pack.
4. Rerun the test. If the test continues to fail, replace the standby PN
Expansion Interface circuit pack.
5. Rerun the test. If the test continues to fail and the standby link is on B
side, replace the ICC cable or IPSI faceplate cable that carries the
serial link from Expansion Interface or IPSI circuit pack B to the PN’s
Maintenance circuit pack.
PASS The serial link from the standby Expansion Interface or IPSI to the PN’s
Maintenance circuit pack is working.
Table 542: Test #337 PN Maintenance Circuit Pack Serial Link Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2