Communication Manager Maintenance-Object Repair Procedures
824 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Conference Circuit Test (#7)
Note:
Note: S8300 / G700: This test aborts with Error Code 1412.
The Conference Circuit test verifies that the NPE channel for the port being tested can correctly
perform the conferencing function. The NPE is instructed to listen to several different tones and
conference the tones together. The resulting signal is then measured by a Tone Detector port.
If the level of the tone is within a certain range, the test passes.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, an insane board is inserted, or the board is hyperactive.
1. Verify that the board’s translations are correct. Enter list config,
and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, enter busyout
board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the linkage between the internal ID and the port. If
not, dispatch to verify that a valid board is inserted.
Note:
Note: Hyperactivity causes some special problems with the
sequence suggested above. If the ports are translated after
entering list config but the Vintage field reports that
there is no board (when there really is a board), then
busyout board and release board do not work, but
reset board location works. The software puts the
hyperactive board back in service after the hyperactivity
clears.
Table 282: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
4 of 4