Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
PKT-INT (Packet Interface)
Issue 1 June 2005 1835
1 FAIL Setting up peer links between the active and standby IPSI circuit pack’s
Packet Interface modules failed. The standby IPSI circuit pack’s Packet
Interface module did not respond to the peer link setup.
1. This may be the result of old firmware not supporting new software
operation. Verify the IPSI circuit pack’s firmware vintage and download
the new firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been corrupted.
Download the firmware image.
3. Retry the command.
4. If the same Error Code occurs, use display alarms to display
active alarms.
5. If errors related to the packet bus exist, see PKT-BUS (Packet Bus)
on
page 1790 and clear those problems first.
6. Retry the test command after a 1-minute delay.
7. If the test continues to fail, replace the standby IPSI circuit pack.
2 FAIL Setting up peer links between the active and standby IPSI circuit pack’s
Packet Interface modules failed. The active IPSI circuit pack’s Packet
Interface module did not respond to the peer link setup.
1. This may be the result of old firmware not supporting new software
operation. Verify the IPSI circuit pack’s firmware vintage and download
the new firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been corrupted.
Download the firmware image.
3. Retry the command.
4. If the same Error Code occurs, retry the test command after a one
minute delay.
5. If the test continues to fail, replace the IPSI circuit pack.
PASS The media server can communicate with the IPSI circuit pack’s Packet
Interface module.
1. If problems are still reported on the Packet Interface, check for failures
using the Private Loop-around test (#885) and Maintenance
Loop-around test (#886).
Table 673: Test #888 Active-Standby Peer Link Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3