Filter
Top Products
NO-LIC (No License)
Issue 1 June 2005 1727
NO-LIC (No License)
S8700 | 8710 / S8500 / S8300
Note:
Note: The NO-LIC MO (No License) is non-traditional in that there are no associated
tests or commands that you can execute.
How systems go into No-License mode
The NO-LIC MO works with the LIC-ERR MO to find any errors/violations associated with the
License File. Once a License File error occurs, LIC-ERR logs the error, raises an alarm, and
generates the following SAT login message:
“System Administration Will Be Blocked in Approximately XXX hours.
Contact Your Service Representative.”
Entry into License-Error mode starts a timer that, when expired, causes the system to enter
No-License mode (see Figure 98: License mode algorithm
on page 1728). When
Communication Manager enters No-License mode, the following SAT warning message
displays:
“System Administration Is Blocked.
Contact Your Service Representative Immediately.”
The system also responds with these conditions:
● “LICENSE ERROR” displays on all stations and consoles when they go off-hook, but
disappears when the first digit is pressed. This display message does not interfere with the
normal use of any station or console.
● All terminal-login sessions are terminated.
● Any subsequent terminal-login sessions are limited to
- Maintenance commands.
- License File installation command.
MO Name in
Alarm Log
Alarm
Level
Initial Command to Run Full Name of MO
NO-LIC MAJ None NO License