Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
EXP-PN (Expansion Port Network)
Issue 1 June 2005 1239
PN Warm Restart (#956)
The PN Warm Restart, or PN Reset Level 1, reset port-network P level 1 is used to
restart a PN that has not been taken out of service. It is the least severe of the PN restart levels
and is used in an attempt to preserve the state of the system as much as possible, thereby
reducing user impact. This restart is attempted on a PN if it is still in service, or as a result of a
system technician-demanded PN Warm Restart.
During a PN Warm Restart all calls are preserved including voice, data, and packet calls. Once
an event has occurred that requires a warm restart, service is fully restored within 35 seconds.
Table 420: Test #956 PN Warm Restart
Error
Code
Test
Result
Description / Recommendation
2100 ABRT Could not allocate the necessary system resources to execute this reset.
1. Retry the command at 1-minute intervals up to 3 times.
1386 ABRT The system link to this PN is unavailable and cannot be used. This reset
cannot be executed without the link being operational.
1. See SYS-LINK and resolve the link problem.
1387 ABRT This PN is not in a state where it is possible to perform a Warm Restart on
the PN. It is necessary to perform a PN Cold Restart (PN Reset Level 2)
because of one of the following reasons:
The PN is in an out-of-service state.
Insufficient time has elapsed since the last PN Cold Restart was
performed on this PN.
2000 ABRT Response to a request made in the internal portion of this reset procedure
was not received within the allowable time period.
2500 ABRT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL Internal system error
1. Retry the reset command at 1-minute intervals up to 3 times.
PASS The PN Warm Restart procedure completed successfully.