Filter
Top Products
DTMR-PT (Dual-Tone Multifrequency Receiver Port)
Issue 1 June 2005 1117
System Technician-Demanded Tests:
Descriptions and Error Codes
Investigate tests in the order presented.
Tone Detection Verification Test (#42)
This test checks the touch-tone digits detection capability of the DTMR port.
Order of Investigation Short Test
Sequence
Long Test
Sequence
D/ND
1
1. D = Destructive; ND = Nondestructive
Tone Detection Verification test (#42) X X ND
Tone Detector Audit/Update test (#43) X X ND
Table 380: Test #42 Tone Detection Verification Test
Error
Code
Test
Result
Description / Recommendation
ABRT The system could not allocate enough resources for this test, or there was
an Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1 ABRT The system could not allocate enough resources to test the DTMR port.
1. Retry the command at 1-minute intervals up to 5 times.
1001 ABRT The system was unable to put the DTMR port in the mode to test it.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABRT The system could not allocate time slots for the test connection. This could
happen when the system is heavily loaded. If the system is not heavily
loaded, then test the TDM Bus via the test tdm [a|b].
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2