Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
2444 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Translation Update Test (#146)
The Translation Update test sends the circuit-pack-level information specified by System
Administration to the UDS1 Interface circuit pack. Translation includes the following data
administered for a UDS1 Interface circuit pack (see output of display ds1 location): DS1
Link Length between two DS1 endpoints, Synchronization Source Control, All Zero
Suppression, Framing Mode, Signaling Mode, Time Slot Number of 697-Hz Tone, Time Slot
Number of 700-Hz Tone, etc.
If a TN464F or later UDS1 circuit pack is combined with a 120A1 CSU module or the 401A T1
sync splitter to screen an Integrated CSU module/T1 sync splitter, this test will also send the
administration for this Integrated CSU to the circuit pack to assure the board’s translations are
correct. The administration of the CSU module/T1 sync splitter is done using the DS1 Circuit
Pack administration screen. Translation for the CSU module/T1 sync splitter includes the
following data: Transmit LBO, Receive ALBO, Supply CPE Loop-Back Jack Power.
0NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board
is inserted, or an insane board is inserted.
1. Verify that the board’s translations are correct. Execute add ds1
location to administer the UDS1 interface if it is not already
administered.
2. If the board was already administered correctly, check the error log
to determine whether the board is hyperactive. If so, the board was
shut down. Reseating the board will re-initialize it.
3. If the board was found to be correctly inserted in step 1, then enter
busyout board location.
4. Enter reset board location.
5. Enter release board location.
6. Enter test board location long.
This should re-establish the linkage between the internal ID and the port.
Table 865: Test #145 Misframe Alarm Inquiry Test (continued)
Error
Code
Test
Result
Description / Recommendation
5 of 5