Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
1274 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
120 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with the equipped
SNI in slot 20. Use list fiber-link to see a fiber link’s endpoints.
1. Perform the Fiber link fault isolation
in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300192). This should
resolve multiple SNI-PEER errors.
2. If the SNI being tested has SNI-PEER Error Type 3841, replace the
SNI being tested. (Replacing an SNI may be service interrupting.
Refer to the SNI-BD section for the procedure to replace an SNI.) To
view SNI-PEER errors, use display errors with category
PNC-PEER. Retry the command.
3. If the SNI being tested still has SNI-PEER Error Type 3841, replace
the SNI in slot 20.
133 FAIL No neighbor link is assigned, but the SNI (Endpoint 1) has an EI neighbor.
Use list fiber-link to see a fiber link’s endpoints.
1. Administer the SNI on a fiber link to the EI neighbor it is connected to
via add fiber-link next. Or remove both fiber endpoints (i.e., this
SNI and its EI neighbor) and remove the fiber endpoints from circuit
pack administration via change circuit-pack.
134 FAIL No neighbor link is assigned, but the SNI (Endpoint 1) has an SNI
neighbor. Use list fiber-link to see a fiber link’s endpoints.
1. Administer the SNI on a fiber link to the SNI neighbor it is connected to
via add fiber-link next. Or remove both fiber endpoints (i.e., this
SNI and its SNI neighbor) and remove the fiber endpoints from circuit
pack administration via change circuit-pack.
135 FAIL The SNI circuit pack (Endpoint 1) cannot communicate with its assigned
neighbor. Use list fiber-link to see a fiber link’s endpoints.
1. Check if the administered neighbor is inserted. If not, insert the
neighbor circuit pack.
2. Perform the Fiber link fault isolation
in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300192).
136 FAIL The Endpoint 1 SNI’s administered neighbor does not match the physical
neighbor connected. Use list fiber-link to see a fiber link’s
endpoints. The SNI’s assigned neighbor is another SNI, but the SNI is
physically connected to an EI. Enter list fiber-link and verify that the
fiber-optic and metallic cables are installed as administered.
Table 440: Test #759 Configuration Audit (continued)
Error
Code
Test
Result
Description / Recommendation
10 of 22