Filter
Top Products
ISDN-TRK (DS1 ISDN Trunk)
Issue 1 June 2005 1469
● clear isdn-testcall grp#/mem#
This command terminates an outgoing test call already in progress. Measurements already
collected are not cleared until the next test call begins.
A PASS of the asynchronous test indicates only that the test call was successfully established.
Use status and list to get the results of the test.
Note:
Note: Before attempting to make an ISDN-PRI test call to the public network (that is,
the network of the far end), make sure that test call service is provisioned by the
network. The user must subscribe to Test Type 108 service and have the correct
far-end test call number administered on the trunk group form for the call to be
allowed.
Table 530: Test #258 ISDN Test Call
Error
Code
Test
Result
Description / Recommendation
4 ABRT There is a problem with the Signaling Channel.
1. Consult the procedures for the ISDN-PRI Signaling Group
(ISDN-SGRP). Further information may also be obtained by consulting
the procedures for the ISDN-PRI Signaling Channel (ISDN-LNK).
8 ABRT There is a problem with the DS1 interface circuit pack.
1. Consult the procedures for the appropriate DS1 interface circuit pack
(DS1-BD or UDS1-BD).
1004 ABRT B channel in use.
1. Enter status trunk grp#/mem# to determine whether a call is
active on this DS1 ISDN trunk.
2. When the service state indicates in service/idle, retry the test.
1005 ABRT Bad Configuration (such as no Maintenance/Test circuit pack)
1. Make sure the Maintenance/Test circuit pack is inserted.
2. Repeat the test.
1018 ABRT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
1 of 6