Filter
Top Products
RDIG-STA (Remote Digital Station)
Issue 1 June 2005 1937
Digital Station Audits Test (#17)
This is a series of six tests that are classified as audits. The media server sends messages to
the on-board microprocessor to perform the tests. These audits run only if the station is
in-service.
● Switchhook Inquiry test: This updates the media server’s records according to the circuit
pack’s records. This inquiry is sent all the way to the voice terminal.
● Bad Scan Inquiry test: This sends an up-link message containing a generated count based
on certain events relating to the link’s conditions. This indicates communications problems
between the media server and Digital Port circuit pack.
● EPF/PTC Inquiry test: This sends an up-link status message of the Electronic Power Feed
(EPF). Possible conditions are: EPF-on-ok, EPF-off.
● ID Request test: This sends a status request to the station. The station returns its
configuration information and health information. The information is checked, and a pass/
fail result is provided.
● Ringer update: This updates the digital telephone’s ringer state according to the media
server’s records.
● DTMF Administration update: This sends the digital station a message to refresh its default
value (sending touch tones only) in the primary information channel. This value is initially
set when the station is put in-service and each time the station’s state changes from
another state to in-service.
PASS The message to light every station lamp was sent successfully to the port.
1. Observe the station lamps being lit when running the test. If every
lamps does not light, the other Digital Line test results may indicate
related problems that do not allow the lamps to light.
2. Investigate by using other Digital Line port tests, and by examining the
station, wiring, and connections.
Table 711: Test #16 DIG-LINE Station Lamp Updates Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3