Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
AUX-TRK (Auxiliary Trunk)
Issue 1 June 2005 665
1004 ABRT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port location to determine the trunk group/member
number of the port. Use status trunk to determine the service
state of the port. If the port is active, wait until it is idle.
2. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
7 FAIL The conference capabilities of the port failed.
1. If no service problems exist on the port, continue to use the port until
the circuit pack can be replaced.
129 FAIL The reflective 404-Hz tone test failed, no transmission was detected to or
from the port. The problem may be off-board.
1. To make sure the problem is on-board, disconnect the port from the
auxiliary equipment and retry test.
2. If the test fails, replace the circuit pack. Otherwise, if the test passed
after disconnecting the port from the auxiliary equipment, the problem
is off-board. Check the wiring and connections to the auxiliary
equipment and retry the test after reconnecting the port to the auxiliary
equipment. If the test fails, check the auxiliary equipment. See the
preceding procedure for a failure with Error Code 7.
Note:
Note: If the Looparound and Conference test fails for every port on a
circuit pack, a -5 Volt power problem is indicated. If a TN736 or
TN752 power unit circuit pack is present, the 631DB AC power
unit or the 676B power unit may be defective. The system may
contain either a TN736 or a TN752 power unit circuit pack OR a
631DB power unit, but not both types of power units. To
investigate power problems, see CARR-POW (Carrier Power
Supply) on page 770
Table 225: Test #33 Looparound and Conference (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 4