PKT-INT (Packet Interface)
Issue 1 June 2005 1837
NO
BOARD
The IPSI circuit pack’s Packet Interface module is assigned but is not
detected as physically present.
1. If the IPSI circuit pack is present, replace it.
2. If not, insert a TN2312AP IPSI circuit pack in the assigned slot, and
rerun the test.
5001 ABRT The TDM clock in the Processor port network has failed.
1. See TDM-CLK (TDM Bus Clock)
on page 2252 to clear this failure.
5002 ABRT The packet bus in the Processor port network has failed.
1. See PKT-BUS (Packet Bus)
on page 1790 to clear this failure.
Any FAIL The diagnostic tests failed for the IPSI’s Packet Interface module failed. If
the system is equipped with the high-reliability or critical-reliability
configuration on an S8700 Multi-Connect or on an S8700 IP Connect, the
reset runs only on demand if the Packet Interface is on the standby IPSI
circuit pack, or if Packet Interface is in an out-of-service state on the active
IPSI.
1. This may be the result of old firmware not supporting new software
operation. Verify the IPSI circuit pack’s firmware vintage and download
the new firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been corrupted.
Download the firmware image.
3. Retry the command.
4. If the same Error Code occurs, retry reset packet-interface.
5. If the reset fails, replace the IPSI circuit pack.
PASS The IPSI’s Packet Interface diagnostic software passed. The Packet
Interface is put back into service automatically.
Table 674: Test #889 Reset Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2