Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
AN-LN-PT (Analog Line Port)
Issue 1 June 2005 439
1 FAIL The switchhook audit failed. This result does not indicate a hardware
problem. The other updates were not performed because of this failure.
This may occur if the audit is performed at the same time the terminal
equipment goes off-hook.
1. Use status station extension to determine when the port is
available.
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to fail, escalate the problem.
5 FAIL The message waiting lamp update failed. This may be an internal software
error. The translation and ringer updates were not performed because of
this failure.
7 FAIL The translation update failed. There may be an internal software error. The
ringer update was not performed because of this failure.
8 FAIL The ringer update failed. There may be an internal software error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
PASS The software and the port processor have the same status. Investigate
user-reported troubles on this port by running other port tests, by examining
station wiring, or by inspecting the station.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This result
could be due to incorrect translations, no board is inserted, an incorrect
board is inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Enter
list configuration, and resolve any problems.
2. If the board is correctly inserted, enter busy board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the link between the internal ID and the port. If not,
verify that a valid board is inserted.
Table 129: Test #36 Station Status and Translation Audit and Update (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3