Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
856 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Port Audit Update Test (#36)
This test will send updates of the CO port translation for every port on the circuit pack or media
module that has been translated. The update is non-disruptive and guards against possible
corruption of translation data contained on the circuit pack or media module. No response
message is expected from the circuit pack or media module once it receives translation
updates. The port translation data includes: ground or loop start trunk, tone or rotary dialing
trunk, rotary dialing inter-digit timing, network balance R/RC, and disconnect timing.
Table 292: Test #36 Port Audit Update Test
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1006 ABRT The port has been placed out of service, perhaps by craft busyout.
1. Use display port location to determine the trunk group/
member number of the port. Use status trunk to determine
the service state of the port. If the service state indicates that the
port is active, wait until it is idle before testing.
2. If the port status is idle, retry the command at 1-minute intervals
up to 5 times.
2100 ABRT System resources required to run this test were not available.
1. If the port status is idle, retry the command at 1-minute intervals
up to 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS This test passed. Translation information was successfully updated
on the circuit pack or media module. User-reported troubles on this
port should be investigated by using other port tests and by examining
trunk or external wiring. If the trunk is busied out, the test will not run,
but will return PASS. To verify that the trunk is in-service:
1. Enter status trunk to verify that the trunk is in-service. If the
trunk is in-service, no further action is necessary. If the trunk is
out-of-service, continue to step 2.
2. Enter release trunk to put trunk back into in-service.
3. Retry the test command.
1 of 2