Communication Manager Maintenance-Object Repair Procedures
1316 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Notes:
a. Error Type 0:
Run the short test sequence first. If every test passes, run the long test sequence. Refer to
each appropriate test’s description, and follow its recommended procedures.
b. Error Type 1: Represents a failure of the C-LAN hardware (IP-PROCR in S8300 systems)
carrying the signaling group channel. To determine which C-LAN had been administered for
this signaling group, find the near-end node name on the signaling group form; then
find the C-LAN or IP_PROCR with the same node name on the ip-interfaces form.
Check for errors against the CLAN-BD MO.
c. Error Type 18: Logged when the signaling group in question is busied out by craft. Make
sure, if appropriate, that the signaling group is released from craft busy using the release
signaling-group grp# command.
d. Error Type 257: Tracks failures of the H.323 signaling-group PING test. H.323
signaling-group PING test failures are documented later in this MO.
e. Error Type 513: Tracks excessive round-trip delay of the H.323 signaling-group PING test,
if the round-trip delay exceeds 4 seconds.
f. Error Type: 770: Tracks excessive latency and packet-loss from background IP
measurements collected by the Media Processor Board. Indicates that test packets sent
from a media processor circuit pack to the far-end ip address specified on the signaling
group form have exceeded the IP latency and loss thresholds, as administered on the
system-parameters ip-options form. Exceeding these thresholds indicates that the IP
network may not be providing sufficient quality of service for adequate transmission of
voice. If the signaling group has been administered to enable BYPASS, then error type
1025 also occurs.
g. Error Type 1025: Indicates that the signaling group has been placed into a BYPASS
condition because of IP network congestion. The signaling group accepts incoming calls,
but every outgoing call is denied. The system routes these calls over a secondary route, if
one has been administered.
h. Error Type 1281: Implies that no media processor resources are in service to provide VoIP
connections for the trunk members of the signaling group.
Check for errors against the MEDPRO and MEDPROPT maintenance objects. This error
causes all H323 B Channels to be in an out-of-service near-end state.
2305 (l) Gateway Unregistered Inline Error MIN OFF
2561(m
) Any Registered to LSP Inline Error MIN OFF
Table 455: H323-SGRP Signaling Group Error Log Entries (continued)
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Test to Clear Value
2 of 2