Communication Manager Maintenance-Object Repair Procedures
392 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Battery Feed Test (or Port Diagnostic Test) (#35)
The battery feed chip provides power to the telephone equipment, signaling, rotary dial pulsing,
transmission, and balance. This test checks the signaling and switchhook capabilities of the
battery feed chip by terminating the port, applying battery and detecting the resulting current.
Note:
Note: For the TN746B, Test #35 does not actually run and instead always returns
PASS. Test #35 operates in the normal manner for TN746.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board’s translations are correct. Enter list config,
and resolve any problems.
2. If the board was found to be correctly inserted in step 1, enter
busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the linkage between the internal ID and the
port. If not, verify that a valid board is inserted.
Table 114: Test #7 Conference Circuit Test (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3
Table 115: Test #35 Battery Feed Test
Error
Code
Test
Result
Description / Recommendation
ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 3