Filter
Top Products
XXX-BD (Common Port Circuit Pack/Media Module)
Issue 1 June 2005 2553
2 FAIL The circuit pack or media module failed to restart.
1. Execute command again.
2. If the problem persists, replace the circuit pack or media module.
PASS The circuit pack or media module initializes correctly.
1. Run the short test sequence.
Any NO
BOARD
This is normal if the test is being done when (a) the board is not physically
in the system or (b) the system is booting up. Otherwise, there is some
inconsistency between the physical configuration and the data kept in the
system.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals up to 5 times.
Table 912: Test #53 SAKI Sanity Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2