Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
Communication Manager Maintenance-Object Repair Procedures
1742 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1002 ABRT The test was aborted because the system could not allocate time slots
for the test. The system might be under heavy traffic conditions, or it
might have time slots out of service due to TDM-BUS errors. Use
status health to determine if the system is experiencing heavy
traffic.
1. If the system has no TDM-BUS errors, is not handling heavy traffic,
and the port status is idle, retry the command at 1-minute intervals
up to 5 times.
1003 ABRT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of tone detectors present or some of
the tone detectors may be out of service. Enter list measurements
tone-receiver to display basic information about the system's tone
receivers.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5
times.
1004 ABRT The port has been seized by a user for a valid call. Use status
station or status trunk to determine when the port is available for
testing.
1. Retry the command at 1-minute intervals up to 5 times.
1018 ABRT The test was disabled by translation.
1. You may want to determine why the test has been disabled before
you enable it.
2. To enable the test for the particular analog station being tested, enter
change station extension, and set the Test field on the
Station screen to y.
1020 ABRT The test did not run due to an already existing error on the specific port
or due to a more general error on the circuit pack.
1. Examine the error log for existing errors against this port or the circuit
pack and attempt to diagnose the already existing error. (Error code
1793 indicates a problem with the DS1 interface board, and any
problems on the associated DS1-BD or UDS1-BD should be
resolved first.)
Table 645: Test #7 Conference Circuit Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 5