Filter
Top Products
CLAN-BD (Control LAN Circuit Pack)
Issue 1 June 2005 793
Notes:
a. Error Type 1: Circuit pack stopped functioning or is not physically present.
1. Verify that the circuit pack is present. If circuit pack is present, reset the circuit pack with
reset board location.
● If the error persists, replace the circuit pack.
b. Error Type 18: The C-LAN circuit pack busied out.
c. Error Type 217: applies to 10 circuit packs:
1. Remove the circuit pack(s) against which the error is logged.
d. Error Type 257: Transient communication problem between switch and circuit pack; does
not affect service and can be ignored.
1. Ignore this error, unless the Control Channel Loop Test (#52) fails.
2. If Test #52 fails, replace the circuit pack.
Repetitive failures of the Control Channel Loop test indicate circuit pack hardware failure.
e. Error Type 513: Circuit pack detected and reported hardware failure.
1. Reset the circuit pack with reset board location.
Aux Data:
f. Error Type 769: Logic error. By itself this error may be ignored, but it may result in other
error types being reported.
3862 (ac
)Any
3865 (ad
)Any
3866 (ae
)Any
4352 External RAM error
4353 Internal RAM error
4355 ROM Checksum error
4356 Angel Message Corruption error
4357 Instruction set error
Table 269: CLAN-BD Error Log Entries (continued)
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Test to Clear Value
3 of 3