Filter
Top Products
MODEM-PT (Modem Pool Port)
Issue 1 June 2005 1687
2000 ABRT The response to the test was not received in the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABRT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2103 ABRT The system could not make the conference connection for the test.
1. Retry the command at 1-minute intervals up to 5 times.
4000 ABRT System resources needed to complete the test could not be allocated.
Ordinarily, this means the conversion resource or other hardware used
during the test was in use.
1. Wait 1 minute and attempt the test again.
2. If the same error occurs, use status port to determine whether
the Modem Pool conversion resource is in use.
3. If the conversion resource is in use, and it is absolutely necessary to
test it, the call must be dropped by issuing busyout port
location against the conversion resource. Run the test again.
4. If the same error occurs while the conversion resource is idle,
busyout both Modem Pool conversion resources on the TN758
Pooled Modem circuit pack containing the conversion resource
under test. Run the test again.
5. If the test continues to abort, replace the Pooled Modem circuit pack
and retest.
65515 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2. Enter test port long on the port on which the test aborted. If any
test aborted or failed, follow recommended maintenance strategy for
the appropriate port type (for example, ANL-LINE (8-Port Analog
Line) on page 404, DIG-LINE (Digital Line) on page 924).
Table 623: Test #97 Modem Pool Conference Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3