Communication Manager Maintenance-Object Repair Procedures
472 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
Clear the Announcement circuit pack lock-up remotely by performing a soft reset to the circuit
pack:
1. busyout board location (this command drops all calls in progress on the
Announcement circuit pack)
2. Reset circuit pack using reset board location
3. Release circuit pack using release board location
Playback speech memory array (PSMA) test (#206)
The PSMA test checks the integrity of a playback channel’s interface to the speech memory and
the TDM Bus. The SP has an internal buffer that contains a specific 256-byte sequence. During
this test, the byte sequence is "played" through the 140AY device onto the TDM Bus. A General
Purpose Tone Detector is used to confirm that the proper sequence was played. This test is
very important. It is the only test that actually checks an Announcement Port’s ability to play
back an announcement on the TDM Bus. If the test fails, the Tone Detector returns the number
of bytes that did not match the expected sequence. The larger the number, the more severe the
problem with that port. If this test fails, announcements played over this port should sound
corrupted.
It is the only test that actually checks an Announcement Port’s ability to play back an
announcement on the TDM Bus. If the test fails, the Tone Detector returns the number of bytes
that did not match the expected sequence. The larger the number, the more severe the problem
with that port. If this test fails, announcements played over this port should sound corrupted.
Table 142: TEST #206 playback speech memory array (PSMA) test
Error
code
Test
result
Description/ Recommendation
1000 ABRT System resources required to run this test are not available. The port may be
in use on a valid call.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors. Refer to TDM-BUS (TDM Bus)
on page 2237 to diagnose
any active TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
1 of 3