Filter
Top Products
SN-CONF (Switch Node Configuration)
Issue 1 June 2005 1999
2306 ABRT None of the circuit packs in this switch node carrier are responding to the
processor route messages sent by software.
1. Run test led switch-node for the switch node where this switch
node carrier resides to verify whether the LEDs on any of the boards
light.
2. If none of the LEDs light for the boards in this carrier, fix any problems
associated with the connectivity of this carrier to the server.
a. Use list fiber-link to see the fiber connections to this carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for any
EXP-INTF error entries associated with an IPSI connected PN.
d. Also, follow the repair procedures for any SNI-BD, SNC-BD,
FIBER-LK, or SNI-PEER error entries.
2500 ABRT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL If this test fails, one or more administered circuit packs in this switch node
carrier did not respond with a “board insertion” uplink message. Use list
config carrier location to verify that administered SNI and SNC
boards match the physically installed SNI and SNC boards. The command
output shows NO BOARD for every board that is administered, but not
inserted.
1. If every administered board is inserted, run this test again.
2. If administration does not match the physical configuration, and is
correct, insert the missing circuit packs in this switch node carrier.
3. If administration does not match the physical configuration, and is
incorrect, change the administration, and run this test again.
4. If none of the administered boards in this switch node carrier were
inserted, fix any other SN-CONF errors by following the repair
procedures for SN- CONF. Use display errors with category pnc
to view SN-CONF errors. Use list sys-link to see if any INLs,
LNLs, or RNLs are down. If any INLs, LNLs, or RNLs are down, see
SYS-LINK (System Links)
on page 2175 for fixing link problems.
PASS If this test passes, every administered circuit pack in this switch node carrier
was inserted.
Table 737: TEST #760 Processor Route Audit Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2