Communication Manager Maintenance-Object Repair Procedures
456 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
If the test fails, then it returns the total number of defective announcements found. In addition,
associated with each failure is an error in the Error Log (Error Type 14). The Aux Data indicates
the number of the first defective announcement found. This number corresponds to the
announcement numbers on the announcement form. The extension relating to the
announcement can be determined by display announcement.
Table 135: TEST #209 announcement checksum test
Error
code
Test
result
Description/ Recommendation
0 ABRT An error code of 0 indicates that the announcement file has been corrupted
due to a hardware fault in the TN750 board. Follow step #7 under General
notes on page 465 at the beginning of this section.
1023 ABRT There are no announcements currently recorded on the circuit pack.
1024 ABRT This abort code is given for the following reasons:
1. An announcement upload or download is in progress.
2. An announcement upload or download is requested when this test is
running.
3. A record is in progress.
4. A record request comes in when this test is running.
If an announcement upload or download is in progress, status
data-module <announcement data extension> should show that the
announcement data port is connected to a NETCON data channel, and the
"card-in-use" LED for the memory card is on (to determine the extension of
the announcement data module, use list data-module).
See Note (a
) at end of table for more information.
1. Wait until the blocking event is finished, and then run this test again. An
upload or download could take up to 45 minutes to complete, and a
recording session is finished as soon as the station that was making the
recording is placed on-hook.
2. If the test continues to abort, and a record or upload/download is not in
progress, escalate the problem.
2000 ABRT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the
maintenance strategy recommended for this Error Type.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 3