Filter
Top Products
LIC-ERR (License-Error Mode)
Issue 1 June 2005 1483
- Feature use exceeded prescribed limits
- License expired
- After a system had a valid license, the License file is missing or corrupt.
Note:
Note: System resets do not reset the 30-day timer. If a system in License-Error mode is
reset and the license error remains, the timer picks up the countdown where it left
off.
To clear LIC-ERR alarms, the License file must match the switch hardware and administered
parameters.
● No-License mode
- System software versions do not match.
- License file is missing or could not be installed.
- Offer categories do not match.
- A condition that caused the system to enter License-Error mode has not been corrected
or resolved, and the countdown timer has expired.
- The switch returns to License-Normal mode when every license error is cleared.
Login Warning Messages
Anyone logging onto the SAT (System Administration Terminal) when the system is in
License-Error or No-License mode, receives a warning message stating the system’s Licence
mode, depending on the conditions. Table 532: Error messages and repair procedures
on
page 1483 shows the 3 license modes, the warning message, describes the error conditions,
and lists the recommended repair procedures.
Table 532: Error messages and repair procedures
License
Mode
Description Explanation and repair procedure
License-Normal No mismatches
between license
and hardware
Stable running condition
1 of 2