Filter
Top Products
E-DIG-STA (Emulated Digital Line)
Issue 1 June 2005 1133
1392 ABRT This is currently a TTI port, and the test cannot execute on it.
1. Verify that the port is a TTI port using either display port (the
display shows that the port is a TTI port) or list config (the
display shows a t for the port).
2. If either list config or display port indicates that the port is
not a TTI port, escalate the problem. If both commands indicate that
the port is a TTI port, the abort is correct, and no action is necessary.
FAIL Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The message to light every station lamp was successfully sent to the port.
1. Observe the station lamps being lit when running the test. If every
lamps does not light, the other Digital Line test results may indicate
related problems that are causing the unlit lamps.
2. Investigate by using other Digital Line port tests and by examining the
station, wiring, and connections.
Table 385: Test #16 DIG-LINE Station Lamp Updates Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2