Avaya 03-300430 Home Security System User Manual


  Open as PDF
of 2574
 
ANL-LINE (8-Port Analog Line)
Issue 1 June 2005 413
FAIL The port’s battery feed chip is unable to supply sufficient power to the
terminal equipment. This may occur when the test is performed at the
same time that the terminal equipment goes off-hook.
1. Use status station to determine when the port is available for
testing. When the port becomes available for testing, retry the
command at 1-minute intervals a minimum of five times.
2. If the test continues to fail, determine whether the customer is
experiencing problems on this line. Replace the circuit pack only if the
customer is experiencing problems.
PASS The port’s battery feed chip is able to provide power to the station
equipment to detect on-/off-hook. However, the battery feed chip may still
be unable to provide power for touch-tones. If tones are heard when
buttons are pressed, then the battery feed chip is functioning correctly;
otherwise, replace the circuit pack because this port is defective.
User-reported troubles on this port should be investigated by using other
port tests, by examining station wiring, by examining the station, and by
ensuring that the terminal is correctly translated as off-premises or
on-premises.
Note:
Note: This test always passes for circuit packs TN712 prior to
Vintage 14 and TN742 prior to Vintage 6.
0
NO
BOARD
The test could not relate the internal ID to the port (no board). This could
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board’s translations are correct. Enter list config,
and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, enter
busyout board location
3. Enter reset board location
4. Enter release board location
5. Enter test board location long
This should re-establish the linkage between the internal ID and the port. If
not, dispatch to verify that a valid board is inserted.
Table 121: Test #35 Battery Feed Test Results (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3