Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
500 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
The Deactivated state indicates a problem with the ASAI circuit pack. When in this state, the
Level 1 interface is idle and is not trying to communicate with the BRI endpoints or adjunct.
When an ASAI port is placed in the out-of-service state, Level 1 is also put into the deactivated
state. This could be due either to the system detecting a fault with the port or in response to a
busyout port location request.
Table 152: Test #621 Level 1 Status Inquiry
Error
Code
Test
Result
Description / Recommendation
1187 ABRT The board, port, or station may have been busied-out by a technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port
and ASAI-BD (board busied out). If this error type is present for
ASAI-PT only, then release the port using release port
location and run the test again. If the error is present for both
ASAI-BD and ASAI-PT, then release the board with release port
location and run the test again.
Note:
Note: When you release a port, you release every port
associated with it. If certain ports still need to be busied out,
use busyout port location to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2000 ABRT Response was not received from the circuit pack within the allowable time
period.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack using
busyout board location and reset board location.
2. If the test aborts again, replace the circuit pack.
2012 ABRT Internal system error
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2