Filter
Top Products
ATM-NTWK (ATM Network Error)
Issue 1 June 2005 579
37 (a) User Cell Rate not available
38 (a
) Network out of order. This cause indicates that the network is not
functioning correctly and that the condition is likely to last a relatively long
time. (Immediately retrying the call is unlikely to succeed.)
41 (a
) Temporary failure. This cause indicates that the network is not functioning
correctly, but the condition is unlikely to last long. (Immediately retrying the
call is likely to succeed.)
43 (a
) Access information discarded. This cause indicates that the network could
not deliver access information to the remote user as requested (that is, ATM
adaptation-layer parameters, Broadband low-layer information, Broadband
high-layer information, or sub-address as indicated in the diagnostic).
45 (a
) No VPCI/VCI available. This cause indicates that no appropriate VPCI/VCI
is currently available to handle the call.
47 (a
) Resource unavailable, unspecified. When no more specific cause values
apply, this cause reports a resource-unavailable event.
SERVICE OR OPTION UNAVAILABLE
49 (a
) Quality of Service unavailable. This cause reports that the requested
Quality of Service cannot be provided.
51 (a
) User cell rate not available. This cause reports that the requested ATM
Traffic Descriptor is unobtainable.
57 (a
) Bearer capability not authorized. This cause indicates that a
user-requested bearer capability is implemented by the cause-sending
equipment, but the user is not authorized to use the capability.
58 (a
) Bearer capability not currently available. This cause indicates that the
user-requested bearer capability is implemented by the cause-sending
equipment, but the capability is currently unavailable.
63 (a
) Service or option not available, unspecified. When no more specific cause
values apply, this cause reports an unavailable service or option event.
65 (a
) Bearer capability not implemented. This cause indicates that its sending
equipment does not support the bearer capability requested.
73 (a
) Unsupported combination of traffic parameters. This cause indicates that
the combination of traffic parameters contained in the ATM traffic descriptor
information element (IE) is not supported.
Table 189: Error codes and Aux Data values ATM-NTWK (continued)
Cause
Code/
Error
Type
Aux
Data
Cause Codes Description
3 of 6