Filter
Top Products
HYB-LINE (Hybrid Line)
Issue 1 June 2005 1347
Table 471: Test #61 Hybrid Line Audits Test
Error
Code
Test
Result
Description / Recommendation
ABRT Internal system error
1 ABRT The test was aborted due to an internal system error during the switchhook
audit.
2 ABRT Internal system error occurred during bad scan inquiry audit.
1. Make sure that the station is not in an out of service state.
2. Retry the command at 1-minute intervals up to 5 times.
3 ABRT This port may have been busied out by system technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port. If
this Error Type is present, release the port via release station
extension, and run the test again.
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABRT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Use display port location to determine the station extension
number of the port. Use status station to determine the service
state of the port. If the port is in use, wait until it is idle before testing.
2. If the port status is idle, then retry the command at 1-minute intervals up
to 5 times.
1004 ABRT The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port location to determine the station extension
number of the port. Use status station to determine the service
state of the port. If the port is in use, wait until it is idle before testing.
2. Retry the command at 1-minute intervals up to 5 times.
1392 ABRT This port is currently a TTI port and the test will not execute on it.
1. Verify that the port is a TTI port using either display port (the port is
a TTI port) or list config (shows a t for the port).
2. If either list config or display port indicate that the port is not a
TTI port, escalate the problem. If both commands indicate that the port
is a TTI port, the abort is correct, and no action is necessary.
1 of 2