Filter
Top Products
Communication Manager Maintenance-Object Repair Procedures
572 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
XYZ FAIL A device on the circuit pack is failing. There is at least one bad DSP on the
board. Values are as follows:
● The X value indicates the number of talker DSPs
● Y indicates the number of listener DSPs
● Z indicates the number of Echo Canceler DSPs that have failed the
test.
1. Run the tests for the active Tone-Clock in the PN that contains the
indicted ATM-EI circuit pack to verify that dial-tone is supplied.
2. If the Tone-Clock is healthy, repeat the short test on the ATM-EI board.
3. If this test continues to fail, replace the ATM-EI circuit pack.
XYZ PASS The test passed for some or all DSPs depending on XYZ values. XYZ
indicates the number of talker, listener and echo-canceler DSPs for which
the test passed, respectively. In the DSPs that passed the test, the test tone
was correctly detected by the DSP Listener and by tone-detector for the
DSP Talkers on both buses, and the Echo Canceler DSPs are working
properly.
0
NO
BOARD
No board was detected by the test.
1. Check the Error Log for wrong board (Error Type 125) or no board
(Error Type 131). Resolve either of these issues, if applicable.
2. Check that the board is properly translated and inserted. If so, check
for hyperactivity (Error Type 1538). If hyperactive, use reset board
location.
3. Run the test again. If it fails, the circuit pack could be bad. Replace
the circuit pack and retest.
Table 185: ATM Board DSP Test (#1293) (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3