Communication Manager Maintenance-Object Repair Procedures
1684 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
1000 ABRT
Note:
Note: System resources required for this test are not available.
The port may be in use on a valid call. Determine whether
the port is available for testing.
2. Retry the command at 1-minute intervals up to 5 times.
1001 ABRT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABRT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy
traffic, repeat the test at 1-minute intervals up to 5 times.
1003 ABRT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present or some Tone
Detectors may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5
times.
1004 ABRT The port has been seized by a user for a valid call. Determine whether the
port is available for testing.
1. Retry the command at 1-minute intervals up to 5 times.
1020 ABRT The test did not run due to a previously existing error on the specific port
or because of a more general circuit pack error.
1. Examine the Error Log for existing errors against this port or the
circuit pack, and attempt to diagnose the previously existing errors.
2000 ABRT A response to the test was not received within the allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
Table 622: Test #96 Modem Pool NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3