Filter
Top Products
IPMEDPRO (TN2602AP IP Media Resource 320)
Issue 1 June 2005 1399
Verify NIC Options #1511
This test is conditionally destructive.
This test queries the Media Resource for current network interface parameters of
auto-negotiate, speed, and duplex.
● If the network interface parameters and the administered parameters do not match, the
test updates the board with the administered parameters.
● If the network interface parameters and the administered parameters match, nothing
happens.
0
NO
BOARD
No board was detected by the test.
1. Resolve either wrong board (Error 125) or no board (Error 131)
issues, if applicable.
2. Check that the board is properly translated and inserted.
a. If so, check for hyperactivity (Error 1538).
b. If hyperactive, use reset board location.
3. Run the test again. If it fails, the NCE chip on board may be bad.
Replace the board and retest.
Table 494: Long IP 2-Way Transmission Test (#1506) (continued)
Error
Code
Test
Result
Description / Recommendation
3 of 3
Table 495: Test #1511 Verify NIC Options
Error
Code
Test
Result
Description / Recommendation
1014 ABRT
Board is not inserted. Insert and administer a TN2302 board.
1022 ABRT
Invalid board. The board is not capable of changing its ethernet options.
The board suffix must be D or greater.
1115 ABRT
Unable to allocate system resources (in-use) to run this test. Retry the test
at one minute intervals a maximum of 3 times.
1 of 4