Filter
Top Products
PE-BCHL (PRI Endpoint Port)
Issue 1 June 2005 1783
1004 ABRT The port has been seized by a user for a valid call. Use status
pri-endpoint extension to determine when the port is available for
testing.
1. Retry the command at 1-minute intervals up to 5 times.
1117 ABRT A service state audit message is outstanding.
1. Wait 2 minutes and then try again.
2000 ABRT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals up to 5 times.
2020 ABRT The test did not run due to an existing error on the specific port or a more
general circuit pack error.
1. Examine the Error Log for existing errors against this port or the circuit
pack, and follow recommended procedures.
2100 ABRT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The NPE of the tested port was found to be transmitting in error. This will
cause noisy and unreliable connections. The PE-BCHL is moved to
out-of-service/near-end state.
1. Replace the circuit pack.
PASS The port can communicate over the TDM bus.
Table 658: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 2