Filter
Top Products
TIE-DS1 (DS1 Tie Trunk)
Issue 1 June 2005 2277
1004 ABRT The port was seized by a user for a valid call.
1. Use display port location to determine the trunk
group/member number of the port. Use status trunk to
determine the service state of the port. If the service state
indicates that the port is in use, then the port is unavailable
for certain tests. Wait until the port is idle before retesting.
2. If the port status is idle, retry the command at 1-minute
intervals up to 5 times.
1020 ABRT The test did not run because of a previously existing error on
the specific port or a more general circuit pack error.
1. Examine the Error Log for existing errors against this port
or the circuit pack and attempt to diagnose the already
existing error.
S8500 / G700:
1412
ABRT This test does not execute on a G700 Media Gateway.
2000 ABRT Response to the test request was not received within the
allowable time period.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABRT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2053 ABRT At least one of the following errors is found on the DS1 circuit
pack:
● 1281 — Loss of signal
● 1793 — Blue alarm
● 2049 — Red alarm
● 2305 — Yellow alarm
● 1537 — Hyperactivity
Look for the above Error Types in the Hardware Error Log and
follow the procedures given in the appropriate DS1-BD or
UDS1-BD maintenance documentation for the listed Error
Types.
Table 815: Test #6 NPE Crosstalk Test (continued)
Error
Code
Test
Result
Description / Recommendation
2 of 3