Filter
Top Products
ANN-BD (Announcement circuit pack)
Issue 1 June 2005 457
ABRT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
0-256 FAIL Test failed. The error code indicates the total number of defective
announcements that were found.
When TEST #209 fails with error code 0, the Global Checksum failed on the
board, but no individual Checksum failed.
Note:
Note: Since the announcements are recorded digitally, it is possible
for the Announcement Checksum Test to fail but still have all
the announcements sound uncorrupted. When an individual
announcement fails the Checksum Test, always listen to the
announcement first before taking any action (an
announcement can be played back by dialing the
announcement extension associated with the announcement
number). If the announcement sounds corrupted, then
rerecord it or delete it.
1. Look in the Error Log to determine the number of the first defective
announcement. Play back the announcement. If the announcement
sounds defective, rerecord it or delete it. If the error code was greater
than one (indicating that there is more than one defective
announcement), run this test again and repeat this step.
2. If after deleting and rerecording all defective announcements, the
checksum test still fails, reset the circuit pack using reset board
PCSS and run this test again.
3. If the test still continues to fail, reseat the circuit pack and restore all
announcements with an appropriate time estimate (for example, 40
minutes.) Then rerecord the lost announcements (that is, those
recorded since the last save operation) and run this test again.
4. If the test still continues to fail, replace the circuit pack, and run this test
again.
!
WARNING:
WARNING: Replacing the circuit pack results in loss of integrated
announcements. See General notes
on page 465 near the
beginning of this Maintenance procedure.
Table 135: TEST #209 announcement checksum test (continued)
Error
code
Test
result
Description/ Recommendation
2 of 3