Filter
Top Products
MAPD-BD (MAPD Interface Circuit Pack TN802)
Issue 1 June 2005 1511
Note:
Note: Local restore of a complete system from the PCMCIA disk should not require
more than 20 minutes assuming that a replacement MAPD pack is available and
pre-loaded with the IP trunk application software.
Restoring Data from the PCMCIA Disk
Before You Start
1. Shut down the application running on the circuit pack. See Shutting Down NT on the
TN802 on page 1529.
2. Remove the defective IP Trunk circuit pack from the switch (if applicable).
3. Install the replacement IP Trunk circuit pack in the switch (if applicable).
4. Insert the backup diskette into the IP Trunk circuit pack.
5. Wait Backup can take as much as 20 minutes to complete.
6. Release circuit pack At the S8700 Media Server terminal, type release board
location (the address of the TN802 circuit pack), and press
Enter.
Table 545: Backing up TN802 administration data (continued)
Step Description Comments
2 of 2
Table 546: Restore TN802 administration data
Step
Description Comments
1. Restore IP
Trunk
administration
At the Windows 2000 desktop, double-click on the IP Trunk
Backup/ Restore icon.
The IP Trunk Backup/Restore Utility screen appears.
2. Select utility In the IP Trunk Backup/Restore Utility dialog screen, click Files>
Restore.
The IP Trunk Backup screen appears.
3. Select restore In the IP Trunk Backup screen, click on the Restore button.
4. Wait Wait until the amber Disk-In-Use LED (Note 5 in Figure 84: TN802
faceplate on page 1513) light is out.