Filter
Top Products
98 FSN Series • User’s Guide • Rev 01
3. Control Panel Orientation
Control Panel Descriptions
~ Use the decimal button (.) for numeric entries that accept decimal values.
~ Press ENTER to complete a store, recall, or numeric entry function. For
store and recall functions, once pressed, the selected modules are
stored to memory or recalled to the panel, and all lit buttons in the
Memory Section turn off.
gçóëíáÅâ
The Joystick is a three axis controller that is used to adjust a variety of switcher
parameters. The figure below illustrates the Joystick and its three axes of control:
Figure 3-23. Joystick
For example, on the DVE Menu, when the Size and Position Tab is selected, the
Joystick manipulates the PIP’s size and position as follows:
• X-Axis Control — Move the Joystick left and right to move the PIP left and right,
respectively.
• Y-Axis Control — Move the Joystick up and down to move the PIP up and down.
• Z-Axis Control — Twist the Joystick’s top knob clockwise to increase PIP size, or
counterclockwise to decrease PIP size.
In Chapter 8, refer to the “Joystick Control” section on page 361 for additional details on
specific DVE Joystick control functions.
.
Note
The decimal button is only applicable when certain Touch
Screen keypad functions that accept decimal values are
active. The button does not apply to memory registers.
ENTER
X-Axis Control
Y-Axis Control
Z-Axis Control