Filter
Top Products
28 FSN Series • User’s Guide • Rev 01
NK==fåíêçÇìÅíáçå
New Feature Review
• M/E 2 Control
Version 2.0 supports control of M/E 2 from the FSN-150. All M/E 2 outputs on the
FSN-1400 are active, a new M/E Setup Menu is provided, and the M/E 2 button
in the Memory Section is active. In Chapter 5, refer to the “Other Setup Menu”
section for setup details. In Chapter 7, refer to the “M/E 2 Control on the FSN-
150” section for M/E 2 operating instructions.
• NIC Gamma Adjustment
Gamma adjustment has been added to all NIC (Native Input Card) inputs. The
adjustment range is 0.5 to 3.0, in .01 increments. In Chapter 5, refer to the “Input
Menu” section on page 202 for details.
• Ancillary Data Support for SD Rates
For SD (standard definition) formats, for direct NIC-to-AUX output routes, ancillary
data present on NIC inputs is now preserved to SDI Aux outputs. However, if the
signal travels through an M/E, a UIC or the DVE, ancillary data is stripped. Please
note the following important points:
~ In Frame Sync mode, if a frame is repeated or dropped, the ancillary
data for that frame is also repeated or dropped.
~ For HD (high definition) video formats, the same rules apply.
• Video Reference Output
On the Reference and Output Setup Menu, new features are provided:
~ Users can adjust the reference video output by toggling the {Reference
Out} button to either Black Burst or Tri-level Sync.
~ By pressing {Reference Output Timing}, users can adjust H and V
phase relative to video reference input.
Please note:
~ In Chapter 2, refer to the “System Card” section on page 44 for
information on the Ref Out connector.
~ The sync out format (as provided on the Ref Out BNC) changes,
depending on the selected native video format. In Appendix A, refer to
the “Reference Video Output Specifications
” section on page 434 for
details on each format.
• Additional Native Video Output Formats
Three new native video output formats have been added to the system:
~ 1920 x 1080p @ 23.98
~ 1920 x 1080p @ 24
~ 1920 x 1080p @ 25
Please note:
~ Use the Reference and Output Setup Menu to select the desired native
output format. In Chapter 5, refer to the “Reference and Output Setup
Menu” section on page 197 for menu details.
~ In Appendix A, refer to the “Output Formats” section on page 449 for a
complete list of all available output formats.
Important
This change activates the Ref Out BNC connector on the
System Card’s rear panel.