Filter
Top Products
FSN Series • User’s Guide • Rev 01 117
4. Installation
Card and Rear Panel Installation
oÉ~ê=m~åÉä=fåëÉêíáçå
To insert a rear panel:
1. Use Table 4-4
on page 116 to verify the slots in which the cards and their
corresponding rear panels can be installed. Front and rear slot numbers will
match. For example, if you install a NIC in front slot 1, its corresponding rear
panel must be installed in rear slot 1.
2. If a blank rear panel is installed in the target slot, loosen the two captive thumb
screws in the blank panel, remove it, and store it safely.
3. Ensure that the selected rear panel is properly oriented:
~ NIC: orient the SDI label at the top.
~ UIC: orient the label “1” at the top.
~ NAC: orient the SDI label at the top.
~ UOC: orient the label “1” at the top.
~ MVR: orient the label “1” at the top.
~ DVE: A rear panel is not required. Leave the blank panel installed.
4. Using the nylon guides in the chassis for alignment, carefully insert the rear panel
into the chassis. Be sure to push on both the top and bottom thumb screws
simultaneously, until the card is fully seated in the chassis connector.
5. Once the panel is fully seated, tighten the two thumb screws.
6. Repeat from step 1 for all additional rear panels that you want to install.
oÉ~ê=m~åÉä=oÉãçî~ä
To remove a rear panel:
1. Loosen the two captive thumb screws in the rear panel, and carefully remove it
from the FSN-1400 chassis. Store the panel safely for later use.
2. Install a blank panel in its place.
3. Repeat from step 1 for all additional rear panels that you want to remove.
Caution
Always push both thumb screws simultaneously. If you only
push on one, you can damage the panel or bend a pin.
Important
Unused rear slots must always have blank panels installed.